Head_L Head_R
     
   
 
Request a Quoatation

Side Top
  Home
  Site Map
  About HM Wire
  Glossary of Terms
  Testing Information
  Bare Wire Dimmension Chart
  Calculations
  Videos

  www.litz-wire.com
  ~out sister site~

Choose a Language

powered byGoogle Logo

Search HMWire.com:
enhanced byGoogle Logo

Get Adobe Reader Now

Get Adobe Flash

RoHS and WEEE Compliance

Side Bottom


Flat Magnet Wire

Flat Magnet Wire is produced from round pre-insulated magnet wire that is flattened between mirror polished work surfaces. Insulation is stressed in only one direction, and resistance and wire gauge remain largely unchanged. Wire comes in 10 or 20 lb spools and 5 ratios of thickness to width. User can select cross sectional area in sq mm or sq mil, or in terms of wire resistance. Insulation is Polyester/Polyamideimide or Polyester/Polyamideimide/Bondcoat.

Flat magnet wire is useful in products such as voice coils in loudspeakers, field and armature coils in rotary and linear motors, and transformers, in which the flat wire permits more compact coils and improved heat dissipation, as compared to designs based on round wire.

Flat wire is available with two types of insulation:

Polyester/Polyamideimide
Polyester/Polyamideimide/Bondcoat

180°C Bondable
200°C
240°C

If you'd like a quotation and know your specifications, click here

We offer AWG 11 – AWG 32 with Ratios of 1:2, 1:2.5, 1:3, 1:3.5, 1:4, but we can sometimes optimize a design even further than possible with the fixed ratios.

THE PROCESS OF FLATTENING WIRE

The wire that is already insulated or bare wire is flattened by making use of proprietary gear in a solitary process of deformation between mirror refined work surfaces. It is critical for the deformation process that it is performed with insignificant elongation. This means that the cross sectional area is reduced only slightly. The consequence is that even at the highest ratio of deformation, which is 1:4, the insulation is extended no more than 25% on the flat wire, and also in one direction only (crosswise).

Flattening conserves the reliability of virtually all types of insulation including high temperature polymide/imide coatings and bond-coats as well as solderable polyurethanes(MW16, MW35, MW79, MW80). Studies of sections of flattened wire show unbroken rather than a pointed conversion from the flats into semi elliptical edges, and do it with basically no stress concentrations. The flat wire also does not display the “dogbone” profile often shown in post insulated rectangular wire. This is due to surface tension deriving the varnish away from the wire edges.

WORK HARDENING

Depending on what ratio the customer selected, the procedure usually engages an extent of work hardening. This leaves the wire fairly harder than post insulated wire. The amplified rigidity is perceived as a benefit in some applications.


 
   
Footer Box Top
 
Home | Site Map | Links | Legal | About
Phone: 330-244-8501 | Fax: 330-244-8561
PO Box 9181 Canton, Ohio 44711
Copyright © 2007-2010 HM Wire International, Inc. All Rights Reserved.
Site Designed and Maintained by HmDesigns
 
Footer Box Bottom
 
Left Footer
Version 4.3.2
Right Footer